Oil Treatments

High-tech ceramic engine wear protection for all motor oils. Cera Tec is added to the motor oil to reduce friction and wear. Chemically and thermally highly stable micro-ceramic particles have a low-friction effect and reduce fuel consumption. Sufficient for up to 5 litres of engine oil.

Engine Flush is a specially formulated combination of additives and carrier fluid. In combination with the carrier fluid, the highly effective detergent and dispersant additives dissolve sludge and lacquer formers. All types of oil-soluble and oilinsoluble residues are brought into suspension and removed during the next oil change. An engine which has been cleaned of deposits and contamination and which is then filled with fresh oil not contaminated with old impurities can develop its full performance characteristics.

Damps the noise produced by worn hydraulic lifters. Cleans valves and holes in the lifter and promotes optimum operation.

The highly effective detergents and dispersants loosen the sludge and lacquers, and keep both solid and liquid contaminants in suspension until they are drained with the oil motor oil. 500 ml is sufficient for 5 litres of engine oil.

Regenerates rubber and plastic engine seals such as shaft seals and valve stem seals and prevents oil stains under the vehicle. Counteracts oil dilution. Reduces engine noise and oil consumption through piston rings and valve guides.

Fully synthetic engine-oil additive. Significantly reduces wear. High-pressure anti-wear additive forms a very thin layer on friction pairs inside the engine. The layer has ductile and lubricating properties and is effective for at least 50,000 km. The advantages are as follows: ˜ Significant reduction in wear ˜ Longer service life for the engine˜ Reduced fuel consumption and pollutant emissions due to the energy conserving effect ˜ Optimum engine performance and quieter running.

The anti-friction lubricant MoS2 forms a high load-bearing film of lubricant on all friction and sliding surfaces. This product reduces friction and guarantees energy-conserving performance for the unit. This yields the following advantages: significant savings in fuel and oil consumption, scientifically proved reduction in wear, fewer break-downs, emergency lubrication properties. Tested on catalytic converters and turbochargers.

Removes oil sludge from engine. Keeps oil screens and oil ways free. Use before the oil change. 300 ml is sufficient for max 5 litres of engine oil. Mix with the engine oil 100 - 300 km before changing the motor oil.

Designed to minimize blue exhaust smoke and improve compression in engines that consume and burn engine oil excessively. Based on a superior viscosity index improver material, Oil Smoke Stop is effective over an extended length of time, maintaining oil viscosity at higher level. It may be added at the time of the oil change, and between oil changes if oil cunsumption is very high.

Prevents oil thinning. Thanks to better sealing of the moving parts the oil consumption is reduced. Use in case of excessive oil consumption and between oil changes.